After seeing my wrapping video, William (from Tennesee) ask me for a few more details on my rod wrapping stand. I built an oak support stand 36″ long and 12″ high that support the rod sections when I wrap guides. The center support can be moved laterally by loostening a wing nut and sliding the support to one side or another. This helps to accommodate the cork/grip on a butt section or to give additional support near the tip-tops on tip sections.
I put groves into the upright supports that can hold two rod pieces and covered them with painter’s tape to prevent any scratching of the bamboo. I hand wrap everything using just a Dr. Slick Bobbin to hold the thread, holding the bobbin in my left hand and turning the rod with my right hand. I wrap all rods with Pearsalls Gossimer silk thread.
When wrapping a guide, my typical wrapping process is to wrap 6 times, then pack the thread with a plastic packing tool (used for modeling clay) that I bought at a crafts store for less than $1, then repeat. It’s the yellow tool you see in the pictures above. The video pretty much shows it all.
Thanks a ton for showing how. I have a set up but much tto short to table. Really like the extra height you made yours. WIll give it a try and thanks again.
Good Luck Bill, and don’t hesitate to check back with me if you have any other questions or ideas.
Dave